Safety Advice; Cleaning Instructions; Before Starting - Palram SanRemo Manual De Instrucciones

IMPORTANT
Please read these
instructions carefully before you start to assemble this product
.
Please carry
out the
steps in the order set
out
in these instructions.
Keep
these instructions
in
a
safe place
for future reference.
Safety advice
For safety purposes we
strongly recommend the product to
be assembled by at least
two
people.
Be
sure
to check that there
are no
hidden
pipes or cables in
the wall before drilling.
Some parts may have sharp edges. Please be careful when handling components. Always
wear gloves,
eye
protection, and long sleeves when assembling or performing any
maintenance
on
your product.
Do not
attempt to assemble the product
in
windy
or
wet conditions.
Do
not attempt to assemble the product if you
are
tired,
have taken drugs,
medications or alcohol, or
if
you are prone to dizzy spells.
Dispose
of
all
plastic bags safely
-
keep them away from children's
reach.
Keep
children away from the assembly
area.
When using
a
stepladder or power tools, make sure
that
you are
following
the manufacturer's safety advice.
Do not climb or stand on the roof.
Do
not hang or
lay on
the profiles.
Heavy articles should not
be
leaned against the poles.
Keep
roof and gutters clear of snow, dirt
& leaves.
Heavy snow load on
the roof
can
make it unsafe to stand below or nearby.
If color was scratched during assembly it
can be fixed.
Cleaning instructions
In
order to clean the product,
use a
mild detergent solution and rinse
with
cold clean water.
Do
not
use acetone, abrasive cleaners, or
other
special
detergents to
clean
the
panels.
Clean the product once assembly
is
complete.
Before starting assembly
Choose
your
site
carefully before beginning assembly.
The ground surface must
be
perfectly flat and leveled and have
a
solid
base such as
concrete, asphalt, deck
etc.
Sort the parts and check against the content parts list.
Parts
should
be laid
out
close at hand. Keep all
small parts (screws etc.)
in
a
bowl
so
they
do
not get
lost.
Please
consult your local authorities
if
any permits
are
required prior to constructing
the product.
Having purchased
a
long patio cover, make sure you received all boxes according
to the additional page (Extending your patio cover) on the instruction manual.
As
soon
as
you are ready
to assemble your patio
cover (you can
start with
this
box), sort the parts and check against the content parts list.
Prior
to enlarging the Patio Cover, several parts need to
be
dismantled, it
is
recommended to
keep
them
in
a safe
place
for future
use.
Note:
Use
only the parts registered
in
the content list, some parts may be surplus.
Tools & Equipment
T001 (Supplied)
Please note:
Anchoring this product to the ground
is
essential
to
its
stability
and
rigidity,
and required
in
order for your warranty to be valid.