During Assembly - Palram SanRemo Manual De Instrucciones

During Assembly
When
encountering the information
icon, please refer to the relevant
assembly step for additional comments and assistance.
During assembly,
use
a
soft surface below the parts to avoid scratches and
damages.
Please make sure you install the panels
with the
UV
protected
side
out (marked with
"THIS SIDE
OUT") and remove the sticker
as
panels are
in
place.
When encountering these icons, you
are
requested to either keep the screws
slightly loose or to fully tighten the screws.
Steps
THIS SIDE
OUT
Step
8: Please
apply silicone sealants above beam 7288
+
7290,
in
order to prevent water
from seeping in
(drawing
b).
Step 12:
Please
note the profile's direction (8063), the canal should
be on
the internal
side.
Step 13: Make
sure
that the angle between the
back wall
profile and the
panel
supporting
profiles
is
90 degrees.
Step 23:
Please
apply silicone sealants to the inner
edges
of parts 7043 & 7042
as
well
as
to
the middle of
parts
7029
+
7039
in
order to prevent water from seeping
in.
Step 24
a +
b:
Please
apply silicone sealant
on
the inner part of 8116 & 8117
(a)
and connect
to the profile (b).
Step 24
c:
Adjust the gutter
head's angle according to your needs and
tighten screw 4043
from the inside.
* It
is
possible to connect standard drainage pipes (2.07" diameter) to the gutter
heads' exit.
Step 28: Important!
Please make sure
the frame
is
perfectly centered before fixing.
Step 31:
Please
do not cut profile 8055
unless needed.
Step 33:
Please
loosen the screws
as
shown
in
diagram
c, set
the beam exactly on top of the
poles, once done re-tighten the
screws.
Step 36:
Important!
Do not over
tighten
the screws.
Use
compatible screws and masonry
anchors for your type
of
base
/
foundation.
Step 37:
Please
do not cut profile 8056
unless needed.
Step 38:
Please
do not cut profile 8057 unless needed.
Please
do not cut the Acrylic sheets 8111 & 8113
unless needed, all
precautions must
be taken.
Step 42: Install the sealing strip on the outer side,
as
shown
in
the diagram.
Step 47: Note the doors' corners should
be at
a
90° angle. Should you have
difficulties
in manipulating the doors, tap on
the door's corner with
a
rubber mallet. (Do not tap
directly
on
the corner,
use
a
small
wooden plank)
Step 51:
Please note! The master key
attached to the doors,
locks
from the inside.
Step 52: Optional! Part 8531
sets
the grey marked doors, thus creating smaller
openings.
* Tighten
all
screws when completing assembly.
Please
note:
The wall anchoring kit supplied with this product
is
suitable only for concrete
walls. Other wall types need an
accordant wall fixation
kit.