Makita DTS131 Manual De Instrucciones página 8

Changing the impact force (Fig. 7)
Impact force grade
displayed on panel
Hard
Medium
Soft
T mode
015147
The impact force can be changed in four steps: hard,
medium, soft, and T mode.
This allows a tightening suitable to the work.
Every time the button
blows changes in four steps.
For approximately one minute after releasing the switch
trigger, the impact force can be changed.
"T" is a special mode for fastening self drilling screws and
bolts. In this mode, the tool starts to drive a screw with
faster rotation, which is suited for drilling with the self-
drilling-screw tip. Once the tool starts to tighten the
screw, it impacts in soft force grade.
NOTE:
• When all lamps on the switch panel go out, the tool is
turned off to save the battery power. The impact force
grade can be checked by pulling the switch trigger to
the extent that the tool does not operate.
• While pulling the switch trigger, the impact force grade
cannot be changed.
• The tool automatically stops to prevent the damages on
the parts during heavy load operation with hard or
medium impact force grade. In that case select the soft
or T mode impact force grade.
8
Maximum blows
DTS131 DTS141
2,500 2,700
–1 –1
(min ) (min )
2,200 2,200
–1 –1
(min ) (min )
1,400 1,400
–1 –1
(min ) (min )
1,400 1,400
–1 –1
(min ) (min )
is pressed, the number of
Application
Tightening when force and
speed are desired.
Tightening when a good
finishing is needed.
Tightening when excessive
tightening need to be avoided
because of potentially
clogged female screw and
broken or damaged screw
head.
Tightening when speed and
good finishing are needed.
Indicating the remaining battery capacity (Fig. 8)
(Country specific)
When you pull the switch trigger, the LED display shows
the remaining battery capacity.
The remaining battery capacity is shown as the following
table.
Battery indicator status
: On : Off
015191
NOTE:
• Approximately one minute after the motor stops, the
indicators go off to save the battery power. To check
the remaining battery capacity, slightly pull the switch
trigger.
Tool / battery protection system
The tool is equipped with a tool/battery protection
system. This system automatically cuts off power to the
motor to extend tool and battery life.
The tool will automatically stop during operation if the
tool or battery are placed under one of the following
conditions. In some conditions, the indicator lights up.
Work
Tightening in underwork
material / Tightening long
screws.
Tightening in the finishing
board, plaster board.
Tightening sash screw/
Tightening small screws such
as M6.
Tightening bolt up to M8.
Tightening when speed and
good finishing are needed.
Tightening bolt up to M8.
Remaining battery
capacity
: Blinking
50% – 100%
20% – 50%
0% – 20%
Charge the
battery