Master Section - Phonic AM 240 Manual Del Usuario

Digital Effect Section (AM240D only)
21. Program Control
This rotary control allows users to select the digital effect
program of your choice. There are 16 points on the rotary
control, each of which corresponds with an effect type. See
the digital effect table for more information.
22. Parameter Control
Turning this control will adjust the one main parameter of
the selected effect. Each effect's parameter can be found
on the digital effect table.
23. EFX "to Main" Control
This will adjust the level of the Digital Effect signal that will
be sent to the Main stereo mix.
24. EFX "to Ctrl" Button
This button is pushed to allow the signal from the Digital
Effect processor to be sent to the Control Room outputs
for monitoring purposes.

Master Section

25. AUX Send Control (AM240 only)
This control adjust the final level of the AUX mix (as taken
from AUX controls on each channel strip), the audio of
which is sent to the AUX send output.
26. 2T Return Controls
Push either one of the buttons in the 2T return control
section selects the destination of the 2T return signal. The
"to Main" sends the signal to the Main stereo mix, whereas
"to Ctrl Rm" button sends the signal to the Control Room/
Phones mix.
21
22
23
24
26
28
4
27. Phantom Power Switch
When this switch is in the on position it activates +48V of
phantom power for microphone inputs, allowing condenser
microphones to be used on these channels. On the
AM240D, the phantom power switch is located on the rear
of the mixer – beside the power switch.
NB. Phantom Power should be used in conjunction with condenser
microphones only. Do not engage Phantom Power if a condenser
microphone is not being used to avoid causing damage to the
mixer's circuitry.
28. Control Room / Phones Control
This control is used to adjust the audio level of the phones
feed, to be sent to the Phones output. This can then be
used in conjunction with headphones or, if required, as an
auxiliary output. This control also adjusts the level sent to
the Control Room output for use in monitoring, as a side
fill, or for the addition of other external devices.
29. Main L-R Control
This control is final level control for the main left and right
audio feed, sent to the Main L and R output.
30. Level Meter
The AM series' level meters give an accurate indication of
when audio levels of the MAIN L/R output reach certain
levels. It is suggested for the maximum use of audio to
set the various levels controls so that the uppermost LED
flashes only occasionally (and perhaps a pinch below that).
The AM240 and AM240D both feature dual 4-segment
level meters.
31. Power Indicator
The power indicator will light up when the power of the
mixer is on.
27
25
31
30
29
AM240 / AM240D