URSUS TROTTER UT-HIDROXPERTEN2 Manual De Usuario página 16

• Connect the water supply hose to the water supply.
Bleed the device as follows prior to operation:
• Turn on the appliance "OFF/ON" •
the lever of the trigger gun.
• Push the lever of the trigger gun, the device will
switch on.
• Let the device run (max. 2 minutes) until the water
exits the trigger gun without bubbles.
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
OPERATION
ATTENTION
Dry running of more than 2 minutes leads to damage
of the high-pressure pump. If the appliance does
not build up pressure within 2 minutes, switch the
appliance off and proceed in accordance with the
instructions in Chapter "Troubleshooting"
High pressure operation
CAUTION
Keep a distance of at least 30 cm when using the jet
for cleaning painted surfaces to avoid damage.
ATTENTION
Car tyres, paint or sensitive surfaces such as wood
should not be cleaned with the dirt blaster, as there
is a risk of damage.
• The washer must be used on a secure and stable
surface in a standing, upright position
• Turn on the appliance "OFF/ON"
• Release the safety lock, then press the trigger for a
few seconds until the water flow is steady.
Unlock
Release the lever of the trigger gun; the device will
switch off again. High pressure remains in the system.
Operation with detergent
Detergent can only be added when the device is
operated in low pressure mode.
DANGER
When using detergents, the material data safety
sheet issued by the detergent manufacturer must
be adhered, especially the instructions regarding
personal protective equipment.
Remove the cap of the clean detergent bottle.
Push the detergent bottle with the opening pointing
downwards into the connection for the hose clean
detergent.
Recommended cleaning method
• Spray the detergent sparingly on the dry surface
and allow it to react, but not to dry.
• Spray off loosened dirt with the high pressure Met.
After operation with detergent
• Remove the hose clean detergent bottle from the
intake and close it with the lid.
• For storage, put the detergent bottle into the
retainer with the cap pointing up.
Interrupting operation
• Release the lever of the trigger gun.
• Lock the lever of the trigger gun.
• Put the trigger gun with the spray lance into the
parking position.
• During longer breaks(more than 5 minutes), also
turn the appliance off using the "OFF/ON" switch.
Finish operation
• Release the lever of the trigger gun.
• Turn off the appliance "ON/OFF".
• Disconnect the mains plug from the socket.
Only separate the high-pressure hose from the
trigger gun or the device when there is no pressure
in the system.