Troubleshooting - URSUS TROTTER UT-HIDROXPERTEN2 Manual De Usuario

TROUBLESHOOTING

DANGER
Risk of electric shook. Turn off the appliance and remove the main plug prior to performing any care and
maintenance work. Repair work and work on the electrical components may not only be performed by an
authorized customer service. You can rectify minor faults yourself with the help of the following overview.
If in doubt, please consult the authorized customer service.
Symptom
Machine refuses to start
Fluctuating pressure
Machine stops
Machine pulsating
Machine starts, but no water
comes out
Machine not plugged in
Defective socket
Fuse has blown
Defective extension cord
Pump sucking air
Valves dirty, worn out or stuck
Pump seals worn out
Fuse has blown
Incorrect mains voltage
Thermal sensor activated
Nozzle partially blocked
Air in inlet hose
Inadequate supply of mains water
Nozzle partially blocked
Water filter blocked
Pump/hoses or accessory frozen
No water supply
Water filter blocked
Nozzle blocked
Cause
Try without the extension cord.
Check that hoses and connections
Leave the washer for 5 minutes
Allow machine to run with open
corresponds to specifications required
Hose kinked
Wait for pump/hoses or accessory
Recommended action
Plug in machine
Try another socket.
Replace fuse. Switch off other
machines.
are airtight.
Clean and replace or refer to
local distributor
Clean and replace or refer to
local distributor
Replace fuse. Switch off
other machines.
Check that the mains voltage
corresponds to specification
on the model tag.
to cool down.
Clean the nozzle
trigger until regular working
pressure resumes.
Check that the water supply
NB! Avoid using long, thin
hoses (min. 1/2")
Clean the nozzle
Clean the filter
Straighten out hose.
Connect inlet water.
Clean the filter
Clean the nozzle
to thaw.