Protection Against Burning And Scalding; Protection Against Electric Shock - NUK VAPO RAPID Manual De Instrucciones

Vaporisator 09/08 Seite 15 Dienstag, 7. Oktober 2008 8:17 08
repairs undertaken by non-qualified per-
sons. The contact address is to be found at
the end of these operating instructions.
• In the event of a breakdown, maintenance
work on the device may only be undertaken
by a qualified person. If this is not adhered
to, any claims under warranty will be
declared null and void.
3.3 Protection against burning and
scalding
Warning! As the device operates at
high temperatures,
of the following warnings can result in
burns or scalds.
• The surfaces of the steriliser become
extremely hot during operation. Therefore
only touch the handle or switches.
• Do not move the steriliser while in opera-
tion. If you do need to move the device
when hot, switch it off first, remove the
plug and wait until it cools down. Otherwise
the surface could cause scalding.
• The bottles are extremely hot after disinfec-
tion and should only be handled using the
enclosed tongs.

3.4 Protection against electric shock

Warning! The
instructions should
against an electric shock.
• Only use the device if both device and
mains lead are intact.
• If the mains lead is damaged it must be
replaced by the manufacturer, his customer
service engineer or a similarly qualified per-
son to prevent potential danger.
•
– Never use outside
– Never place receptacles containing fluid,
– Never use in a humid environment
– Do not use next to a sink.
In the event that fluid gets into the device,
immediately remove the plug and have the
non-observance
device repaired by qualified personnel. The
contact address is to be found at the end of
these operating instructions
•
•
•
•
•
– The extension lead must be suitable for
– The extension lead must not be laid
following safety
protect you
– The extension lead must on no account
– No other equipment should be plugged
15
On no account should water or any other
fluid be allowed to enter the equipment,
except in the intended receptacle. For this
reason:
such as glasses containing drinks, vases
etc. on top of the device
Never touch the device, the mains lead or
the plug with wet hands.
Always remove the lead from the plug.
Never pull on the lead itself.
Ensure that the lead never becomes bent of
squashed.
Keep the lead away from hot surfaces (e.g.
cooker hobs).
Avoid the use of extension leads. These
should only be used in specific cases:
the current specified for the device.
"freely": it must be secured so as to pre-
vent accidents and must be kept out of
the reach of children.
be damaged.
into the socket at the same time, as this
will overload the mains supply (i.e. no
multi-pin sockets to be used!).