Publicidad
Idiomas disponibles
Idiomas disponibles
SPARK ARRESTOR
MAINTENANCE
--
i
WARNING:
To avoid serious personal injury, always turn the
unit off and allow it to cool before cleaning or servicing it.
1,
2.
3.
4.
5.
Remove the engine cover. See Rocker Arm Clearance.
With a flat blade screwdriver or
Torx T-20 bit and a T-25 bit,
remove the screws attaching
the cover to the muffler (Fig. 46).
Pull the tab on the cover out
of the muffler and remove the
cover.
Remove the spark arrestor
screen from the cover.
Clean the spark arrestor
screen with a wire brush or
replace it.
Muffmer
Spark Arrestor
Cover
1"-25
Screw
Slot
1-20
Screw
..//"3r'_
Fig. 46
6.
Reinstall the spark arrestor screen, cover and screw.
CLEANING
Use a small brush to clean off the outside of the unit. Do not use strong
detergents. Household cleaners that contain aromatic oils such as pine and
lemon, and solvents such as kerosene, can damage plastic housing or handle.
Wipe off any moisture with a soft cloth.
STORAGE
• Never store the unit with fuel in the tank where fumes may reach an open
flame or spark.
Allow the engine to cool before storing.
Lock up the unit to prevent unauthorized
use or damage.
Store the unit in a dry, well-ventilated
area.
Store the unit out of the reach of children.
LONG TERM STORAGE
1.
Drain all gasoline from the gas tank into a container. Do not use gas that has
been stored for more than 60 days. Dispose of the old gasoline in
accordance to Federal, State, and Local regulations.
2.
Start the engine and allow it to run until it stalls. This ensures that all
gasoline has been drained from the carburetor.
3.
Allow the engine to cool. Remove the spark plug and put 5 drops of
high quality motor oil into the cylinder. Pull the starter rope slowly to
distribute the oil. Reinstall the spark plug.
NOTE:
Remove the spark plug and drain all of the oil from the cylinder
before attempting to start the trimmer after storage.
4.
Change the oil, referring to Changing the Oil. Dispose of the old oil in
accordance
to Federal, State and Local regulations.
5.
Thoroughly clean the unit and inspect for any loose or damaged parts.
Repair or replace damaged parts and tighten loose screws, nuts or
bolts. The unit is ready for storage.
TRANSPORTING
Allow the engine to cool before transporting.
Secure the unit while transporting.
Drain the gas tank before transporting.
Tighten gas cap before transporting.
POWER STARTER
TM
AND POWER START BIT
TM
FEATURES
This unit is designed to be started with an optional
Power Start
TM
or Power
Start Bit
TM
that are sold separately.
If choosing to use one of these starting
options,
contact your local Craftsman
outlet, call 1-800-4=MY-HOME®,
or
go to www.sears.com/craftsman
for information
and purchasing.
Electric
Start
Feature
item No.
Description
316.85951
........................................
Electric Starter
316.XXXX
.......................................
Power Start Bit
TM
11
Publicidad
