Certification Information (Sar) - Nokia N97 Manual Del Usuario

both the internet calls and the cellular phone. The
device will attempt to make emergency calls over both
the cellular networks and through your internet call
provider if both are activated. Connections in all
conditions cannot be guaranteed. You should never
rely solely on any wireless device for essential
communications like medical emergencies.
To make an emergency call:
1. If the device is not on, switch it on. Check for
adequate signal strength. Depending on your
device, you may also need to complete the
following:
Insert a SIM card if your device uses one.
●
Remove certain call restrictions you have
●
activated in your device.
Change your profile from offline profile mode to
●
an active profile.
If the screen and keys are locked, slide the lock
●
switch on the side of the device to unlock them.
2. Press the end key as many times as needed to clear
the display and ready the device for calls.
3. Open the dialer by selecting the dialer icon (
4. Enter the official emergency number for your
present location. Emergency numbers vary by
location.
5. Press the call key.
154
When making an emergency call, give all the necessary
information as accurately as possible. Your wireless
device may be the only means of communication at the
scene of an accident. Do not end the call until given
permission to do so.

Certification information (SAR)

This mobile device meets guidelines for exposure
to radio waves.
Your mobile device is a radio transmitter and receiver.
It is designed not to exceed the limits for exposure to
radio waves recommended by international
guidelines. These guidelines were developed by the
independent scientific organization ICNIRP and include
safety margins designed to assure the protection of all
persons, regardless of age and health.
The exposure guidelines for mobile devices employ a
unit of measurement known as the Specific Absorption
Rate or SAR. The SAR limit stated in the ICNIRP
guidelines is 2.0 watts/kilogram (W/kg) averaged over
10 grams of tissue. Tests for SAR are conducted using
standard operating positions with the device
).
transmitting at its highest certified power level in all
tested frequency bands. The actual SAR level of an
operating device can be below the maximum value
because the device is designed to use only the power
required to reach the network. That amount changes