Pioneer MVH-S300BT Manual De Instrucciones página 27

USB device/iPhone
FORMAT READ
→ Sometimes there is a delay
between the start of playback and
when you start to hear any sound.
– Wait until the message
disappears and you hear sound.
NO AUDIO
→ There are no songs.
– Transfer the audio files to the USB
device and connect.
→ The connected USB device has
security enabled.
– Follow the USB device
instructions to disable the
security.
SKIPPED
→ The connected USB device contains
DRM protected files.
– The protected files are skipped.
PROTECT
→ All the files on the connected USB
device are embedded with DRM.
– Replace the USB device.
N/A USB
→ The connected USB device is not
supported by this unit.
– Disconnect your device and
replace it with a compatible USB
device.
HUB ERROR
→ The USB device connected via a
USB hub is not supported by this
unit.
– Connect the USB device directly
to this unit using a USB cable.
CHECK USB
→ The USB connector or USB cable
has short-circuited.
– Check that the USB connector or
USB cable is not caught in
something or damaged.
→ The connected USB device
consumes more than maximum
allowable current.
– Disconnect the USB device and
do not use it. Turn the ignition
switch OFF and back to ACC or
ON. Connect only compliant USB
devices.
→ The iPhone operates correctly but
does not charge.
– Make sure the connection cable
for the iPhone has not shorted
out (e.g., not caught in metal
objects). After checking, turn the
ignition switch OFF and back to
ON, or disconnect the iPhone and
reconnect.
ERROR-19
→ Communication failed.
– Perform one of the following
operations, then return to the
USB source.
• Turn the ignition switch OFF and
back to ON.
• Disconnect the USB device.
• Change to a different source.
→ iPhone failure.
– Disconnect the cable from the
iPhone. Once the iPhone's main
menu is displayed, reconnect the
iPhone and reset it.
ERROR-23
→ USB device was not formatted
properly.
– Format the USB device with
FAT12, FAT16 or FAT32.
ERROR-16
→ The iPhone firmware version is old.
– Update the iPhone version.
→ iPhone failure.
– Disconnect the cable from the
iPhone. Once the iPhone's main
menu is displayed, reconnect the
iPhone and reset it.
STOP
→ There are no songs in the current
list.
– Select a list that contains songs.
NO BT DEVICE GO TO BT MENU TO
REGISTER
→ No Bluetooth device found.
– Connect the unit and iPhone via
Bluetooth (page 9).
CONN. FAILED PRESS BAND KEY TO
RETRY
→ Bluetooth connection with iPhone
failed.
– Press BAND/ to make a
connection again.
DISCONNECTED PRESS BAND KEY TO
RETRY
→ Bluetooth connection with iPhone
failed.
– Press BAND/ to make a
connection again.
Bluetooth device
ERROR-10
→ The power failed for the Bluetooth
module of the unit.
– Turn the ignition switch OFF and
back to ACC or ON.
Pandora
ERROR-19
→ Communication failed.
– Disconnect the cable from the
device. Once the device's main
menu is displayed, reconnect the
device and reset it.
NOT FOUND
→ The Pandora application has not
started running yet.
– Start up the Pandora application.
RATING ERROR
→ The thumb rating operation was
disabled.
– Run the same command for
another track.
CAN'T SKIP
→ The skip operation was disabled.
– Run the same command for
another track.
THUMB ERROR
→ Unable to save thumb rating.
– Try again later.
En
27