To Connect The Battery To The Product; Battery Information; Operation; To Charge The Battery - Husqvarna 530iP4 Manual Del Usuario

To connect the battery to the product

WARNING: Only use Husqvarna original
batteries with the product.
1. Make sure that the battery is fully charged.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click.
CAUTION: If the battery does not move
easily into the battery holder, the battery
Introduction
WARNING: Read and understand the safety
chapter before you use the product.

To charge the battery

Note: Charge the battery if it is the first time that you use
it. A new battery is only 30% charged.
1. Make sure that the battery is dry.
2. Put the battery in the battery charger.
783 - 003 - 28.05.2019
3. Make sure that the battery is installed correctly.

Battery information

Refer to the operator's manual of the battery for
information about how to use the battery.
To fill with chain oil
Fill with chain oil after 1 hour of operation or when the
battery is empty.
1. Open the chain oil cap on top of the saw head.
2. Fill with Husqvarna chain oil.
3. Attach the chain oil cap.

Operation

3. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
4. When all LEDs on the battery come on, the battery is
fully charged.
5. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
6. Remove the battery from the battery charger.
is not installed correctly. This can cause
damage to the product.
13