Maintenance - Hitachi Koki SB10Y Manual De Instrucciones

English
GENERAL MAINTENANCE
WARNING
• For you own safety, turn switch OFF and remove the
plug from power source receptacle before maintaining,
cleaning, adjusting, or lubricating your sander.
• To avoid fire or toxic reaction, never use gasoline,
naphtha, acetone, lacquer thinner or similar highly
volatile solvents to clean the sander.
• To avoid eye injury from blowing debris, wear safety
goggles when blowing out sawdust.
CLEANING
Keep machine and workshop clean. Do not allow sawdust to
accumulate on the tool. Keep the drums clean. Dirt on drums
will cause poor tracking and belt slippage. Periodically empty
the dust collection bag.
Be certain motor is kept clean and is frequently vacuumed
free of dust.
Use soap and water to clean painted parts, rubber parts
and plastic guards.

MAINTENANCE

LUBRICATION
The shielded ball bearings in this tool are permanently
lubricated at the factory. They require no further lubrication.
• When operation seems stiff, a light coat of paste wax
applied to the table will make it easier to feed the work
while finishing.
• Do not apply wax to the belt platen. Belt could pick up
wax and deposit it on wheels causing belt to slip.
KEEP TOOL IN REPAIR
• If power cord is worn, cut, or damaged in any way, have
it replaced immediately.
• Replace worn abrasives when needed.
• Replace any damaged or missing parts. Use parts list
to order parts.
– 14 –