Replacing The Filters; Pump Filter - Titan IMPACT 410 Manual Del Propietário

14. Slide the top of the piston rod into the T-slot on the slider
assembly.
15. Position the pump block underneath the pump housing and
push up until it rests against the pump housing.
16. Thread the pump block mounting screws through the pump
block and into the pump housing. Tighten securely.
17. Reassemble the inlet valve assembly into the pump block.
18. For Upright Cart units - Thread the siphon tube into the inlet
valve and tighten securely. Make sure to wrap the threads on
the siphon tube with Teflon tape before assembly. Replace
the return hose into the hose clip on the siphon tube.
19. For Stand / Low Boy units, insert the elbow on the suction set
assembly into the bottom of the inlet valve housing. Push
the retaining ring up into the groove inside the inlet valve
housing to secure the suction set assembly in position. Push
the return hose onto the return hose fitting on the pump
manifold and secure in position with the return hose clamp.
20. Place the front cover on the pump housing and secure in
position using the four front cover screws.
21. Turn on the sprayer by following the procedure in the
"Operation" section of this manual and check for leaks.

Replacing the Filters

English

Pump Filter

1. Loosen and remove the filter housing.
2. Pull the filter from the pump manifold.
NOTE: If the filter breaks off in the pump manifold, use a
small wood screw to remove.
3. Inspect the filter seal. Based on inspection, clean or replace
the seal.
4. Push the new or cleaned filter into the pump manifold.
5. Slide the filter housing over the filter and thread it into the
pump manifold until secure.
Filter seal
Gun Filter
1. Unclip the top of the trigger guard from the gun body.
2. Using the bottom of the trigger guard as a wrench, loosen and
remove the handle assembly from the gun head.
3. Pull the old filter out of the gun body. Clean or replace.
4. Slide the new filter, tapered end first, into the gun head.
5. Thread the handle assembly into the gun head. Tighten with
the trigger wrench.
6. Snap the trigger guard back onto the gun body.
NOTE: For more detail, part number information, and
complete assembly drawings, please see the RX-80
Airless Gun Owner's Manual.
12
Filter housing
Filter
Pump manifold
Gun
Body
Filter
Handle
© Titan Tool Inc. All rights reserved.