Mechanical Specifications - KPS CF100 Manual De Instrucciones

The apparatus uses a 9 V battery (supplied).
To replace the battery, follow these steps and refer
to Figure 4:
1. Disconnect test leads from any power source.
2. Place the apparatus face down on a nonabrasive
surface and loosen the battery-door screw with
a screwdriver.
3. Lift the battery access lid away from the apparatus.
4. Replace the battery as shown in Figure 4.
Observe the battery polarity shown in the battery
compartment.
5. Secure the battery access lid back in position
with the screw.
6. Place the apparatus back in the holster.
Figure 4. Battery Replacement
13
Environmental
Operating Temperature
Operating Altitude
Pollution Degree
Mechanical
Specifications
Weight
Humidity
Safety Specifications
Electrical Safety
Maximum Operating
Voltage (Ume)
Protection Level
14
0 °C to +40 °C
2000 m
2
131 x 72 x 30 mm
(5.2 x 2.8 x 1.2 in)
approx 252 g (0.6 lbs)
15 % to 80 %
Meets DIN VDE 0411
IEC 61010 DIN
VDE 0413-7
EN 61557-7
IEC 61557-7
400 V AC for
all ranges
CAT III 600 V