To Adjust The Harness; Maintenance Schedule; Maintenance - Husqvarna 350BT Manual Del Usuario

1. For 350BT: Put the start/stop switch with throttle
control in the stop position.
2. For 350BF: Push the stop switch.

To adjust the harness

1. Put on the harness of the product.
2. Tighten the shoulder straps until the product is tight
against your body.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.

Maintenance schedule

Maintenance

Clean the external surfaces.
Make sure that the control handle operates correctly.
Make sure that the start/stop switch operates correctly. Refer to
the start/stop switch on page 5 .
Examine the engine, the fuel tank and the fuel lines for leaks. Examine the fuel
filter for contamination. Replace the fuel filter if it is necessary.
Clean the air filter. Replace the air filter if it is necessary.
Tighten nuts and screws.
Examine the air intake and make sure that it is not blocked.
Examine the starter and the starter rope for damages.
Examine the vibration damping units for damages, cracks and deformation.
Make sure that the vibration damping units are correctly installed.
Examine the spark plug. Refer to
Clean the cooling system.
Clean the external surface of the carburetor and the area around it.
10
Maintenance
To do a check of the spark plug on page 11 .
3. Put the waist belt around your waist.
4. Tighten the waist belt strap. Make sure that the
weight of the blower stays on your hips.
To do a check of
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
X
X
X
1246 - 001 - 14.02.2020