Operating Your Water Dispenser; Replacing The Water Bottle; Indicator Lights; Dispensing Water - Avanti WDT40Q3S-IS Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Ø Steps to replace water bottles

Use a clean cloth to wipe off neck of bottle.

Remove cap.

Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands on

opening of bottle while placing in reservoir.

Insert the water bottle on the water intake over reservoir opening so it settles properly on it.

Wipe off any water which may have splashed on dispenser top.

Ø Indicator Lights:

Turn the cooling switch on.

There are 3 indicator lights on the front of the unit. POWER, HOT and COLD

The POWER indicator light will glow indicating the unit is plugged in and the power switch is in the ON

position.

The HOT indicator light will glow after the Power Switch turned on, and the heating process will begin.

When the water reaches the appropriate temperature the HOT indicator light will turn off and the heating

cycle will stop, when the temperature of the water in the reservoir falls below the appropriate

temperature the HOT light will glow indicating the heating system as begun again.

The COLD indicator light will glow after the Power Switch turned on, and the cooling process will begin.

When the water reaches the appropriate temperature the COLD indicator light will turn off and the

cooling cycle will stop, when the temperature of the water in the reservoir rises above the appropriate

temperature the COLD light will glow indicating the cooling system as begun again.

DISPENSING WATER

To dispense hot water:

¨ Slide red safety button to the right and hold while pressing downward on hot water faucet to

dispense hot water.

¨ Safety button will return to its original position when faucet is released.

¨ Ensure all water has dispensed prior to removing glass from the dispensing area.

To dispense cold water:

¨ Press and hold downward on the cold water faucet to dispense cold water.

¨ When you have dispensed the desired amount of water, simply release the cold water faucet.

¨ Ensure all water has dispensed prior to removing glass from the dispensing area.

Wash the inside of the reservoir with a warm water and baking soda solution. The solution should

be about 2 tablespoons of baking soda to a quart of water.

The drip tray and water faucets should be cleaned with mild detergent and warm water.

At regular intervals or once a month inspect the coils located across the back of the dispenser.

Vacuum accumulation of dust or clean it with a soft bristled brush.

If the water dispenser will not be used for a long period of time, unplug the power cord from the

wall outlet.

Drain the water through the faucets.

Turn the POWER switch to the "OFF" position.

Drain the water from the tank by removing the plug from the back of the dispenser.

Unit should not be transported on the sides. Place it upright if possible and cover it with a blanket.