Before the appliance is used, it must be properly positioned
and installed as described in this manual, so read the manual
carefully. To reduce the risk of fire, electrical shock or
injury when using the appliance, follow basic precaution,
Including the following:
?
Plug into a grounded 3-prong outlet, do not remove grounding prong, do not use an adapter, and do not use an
extension cord.
?
It is recommended that a separate circuit, serving only your appliance be provided. Use receptacles that
cannot be turned off by a switch or pull chain.
?
Never clean appliance parts with flammable fluids. These fumes can create a fire hazard or explosion. And do
not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
The fumes can create a fire hazard or explosion.
?
Before proceeding with cleaning and maintenance operations, make sure the power line of the unit is
disconnected.
?
Do not connect or disconnect the electric plug w hen your hands are wet.
?
Unplug the appliance or disconnect power before cleaning or servicing. Failure to do so can result in electrical
shock or death.
?
Do not attempt to repair or replace any part of your appliance unless it is specifically recommended in this
manual. All other servicing should be referred to a qualified technician.
FOLLOW WARNING CALL OUTS BELOW ONLY WHEN APPLICABLE TO YOUR MODEL
?
Use two or more people to move and install appliance . Failure to do so can result in back or other injury.
?
To ensure proper ventilation for your appliance, the front of the unit must be completely unobstructed. Choose
a well-ventilated area with temperatures above 60°f (16
an area protected from the element, such as wind, rain, water spray or drips.
?
The appliance should not be located next to ovens, grills or other sources of high heat.
?
The appliance must be installed with all electrical, water and drain connections in accordance with state and
local codes. A standard electrical supply (115 v ac only, 60 hz), properly grounded in accordance with the
national electrical code and local codes and ordinances is required.
?
Do not kink or pinch the power supply cord of appliance.
?
The fuse (or circuit breaker) size should be 15 amperes.
?
It is important for the appliance to be leveled in order to work properly. You may need to make several
adjustments to level it.
?
All installation must be in accordance with local plumbing code requirements.
?
Make certain that the pipes are not pinched or kinked or damaged during installations.
?
Check for leaks after connection.
?
Never allow children to operate, play with or crawl inside the appliance.
?
If you use the drainage container, you must set the drain select switch to off or the water can overflow from the
drainage container
?
Although the unit has been tested at the factory, due to long-term transit and storage, the first batch of cubes
must be discarded.
?
Do not use solvent- based cleaning agents of abrasives on the interior. These cleaners may damage or discolor
the interior.
?
Do not use this apparatus for other than its intended purpose.
IMPORTA NT SAFEGUIDES
°
c) and below 90°f (32°c). This unit must be installed in
3