Assembly; To Assemble The Mulch Plug (Accessory) - Husqvarna LC247Li Manual De Usuario

decrease the risk of accidents.
Let an approved service agent
do the professional repairs.
Speak to your nearest service
agent for more information.
Only do the maintenance work
•
written in this operator's
manual. More extensive work
must be done by an approved
service agent.
Put on heavy duty gloves
•
when you use the cutting
equipment. The blade is very
sharp and cuts can easily
occur.
Keep the cutting edges sharp
•
and clean for the best and
safest performance.
Introduction
WARNING: Before you assemble the
product, read the safety chapter.
WARNING: To prevent accidental start
during assembly, turn the safety key to 0,
remove the battery and wait at minimum 5
seconds.
To assemble the handle
1. Loosen the lower knobs.
2. Move the knobs to the lower end of the grooves on
the left and the right side of the product. (Fig. 20)
3. Set the handle height in one of the 2 available
positions.
4. Move the knobs up in the direction of the handle until
they stop and you hear a click. (Fig. 21)
5. Tighten the knobs fully.
14
Let your service agent
•
regularly examine the product
and make necessary
adjustments and repairs.
Replace damaged, worn or
•
broken parts.
Obey the instructions for how
•
to change accessories. Only
use accessories from the
manufacturer.
When not in operation, keep
•
the product, battery and
battery charger apart in a dry,
indoor and locked area. Make
sure that children and persons
that are not approved cannot
get access to the product,
battery or battery charger.

Assembly

To assemble the grass catcher
1. Attach the grass catcher frame to the grass bag with
the rigid part of the bag on the bottom. Keep the
handle of the frame on top of the grass bag. (Fig. 22)
2. Attach the bottom section of the grass catcher frame
in the groove on the bottom of the grass catcher.
3. Attach the grass bag to the grass catcher frame with
the clips. (Fig. 23)
4. Lift the rear cover.
5. Attach the grass catcher to the top edge of the
chassis.
6. Put the lower part of the grass catcher into the grass
discharge channel. (Fig. 24)
To assemble the mulch plug
(accessory)
1. Lift up the rear cover and remove the grass catcher.
2. Put the mulch plug into the discharge channel. (Fig.
25)
3. Replace the blade with the mulch blade that is
supplied in the mulch kit. Refer to
247Li, LC 347VLi on page 20 .
Technical data LC
429 - 004 - 15.11.2018