Transportation, Storage And Disposal - Husqvarna LC247Li Manual De Usuario

Keypad Error code (Num-
ber of flashes)
Error LED flashes 3
5
10
2
9
The product stops 8
0
Introduction
WARNING: To prevent unintentional start
during transport turn the safety key to "0",
remove the battery and wait at least 5
seconds.
To set the product in transport
position
1. Loosen the lower knobs.
2. Move the knobs to the lower end of the grooves on
the left and the right side of the product. (Fig. 20)
3. Fold the handle forward. (Fig. 43)
4. Remove the grass catcher.
Transportation
• The Dangerous Goods Legislation requirements
apply to the contained Li-ion batteries.
• For commercial transports special requirements on
package and labels must be obeyed.
• Make sure that you obey the regulations for
dangerous material when you prepare the product
for transport. Local regulations can apply.
• Always remove the battery for transport.
429 - 004 - 15.11.2018
Possible faults
The motor is overloaded
The motor speed drops too
much, and the motor stops
The motor control is too hot
The blade is blocked
Battery error or no signal from
battery
The battery is weak
Battery connector failure

Transportation, storage and disposal

Possible action
Increase the cutting height. See
the cutting height on page 15 .
Stop the motor and wait until it has be-
come cool
To prevent accidental start turn the safe-
ty key to 0, remove the battery and wait
a minimum 5 seconds. Make sure that
the blade can rotate freely. If the prob-
lem continues, speak to an authorised
service agent
Put the battery in the product correctly
and examine the battery connector. If the
error LED on the battery flashes, see
Battery on page 15 .
Charge the battery. See
battery on page 15 .
Examine the battery connector
• Put tape on the battery connectors and make sure
that the battery cannot move around during
transport.
• Attach the product during transport.
Storage
• Always remove the battery for storage.
• To prevent accidents, make sure that the battery is
not connected to the product during storage.
• Keep the battery charger in a closed and dry space.
• Keep the battery and the battery charger in a dry
space where there is no moisture or frost.
• Disconnect the battery from the battery charger
during storage.
• Do not keep the battery where static electricity can
occur. Do not keep the battery in a metal box.
• Keep the battery where the temperature is between
5°C and 25°C and out of sunlight.
• Keep the battery charger where the temperature is
between 5°C and 45°C and out of sunlight.
• Make sure that the battery is charged to 30% - 50%
before you put it in storage for long periods.
• Keep the product, battery and battery charger in a
locked area out of reach for children and not
approved persons.
• Clean the product and do a complete servicing
before you put the product in storage for a long time.
To set
To charge the
19