Troubleshooting Guide - Avanti WIMD332PC-IS Manual De Instrucciones

You can solve many common ice maker problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
Unit does not start.
1. Not plugged in.
2. The circuit breaker tripped or a blown
fuse.
3. The unit is at OFF position.
Compressor and 1. Air blocked the water system.
fan motor work but
no ice made
2. Cooling system leakage
3. Water shortage
Ice can't be 1. Ice melt together because long time
dispensed even
there is ice inside
ice reservoir
ICE MAKER USAGE
For best results and most efficient operation of your ice-maker, it is recommended that
you consume the ice as it is made or store the cubes in a separate container. Ice cubes left
in the ice-bin will begin to slowly melt and the water will re-deposit into the water tray.
• If you are not going to consume the ice cubes as they are made, do not fill the
water tray to the full line while the ice-bin is full.
• When the red "ICE FULL" indicator is on, remove the cubes and store in a
separate suitable container.
• If you plan to leave the unit running overnight, it is recommended that you
remove any cubes left in the bin and store in a separate container.
• If at any time the "ICE FULL" and "ADD WATER" indicators are on and
flashing at the same time, push the POWER button, remove all the ice from the
drawer, check and fill water when needed, wait for 3 minutes and then push
Power button to start the ice making again.
This unit is not designed to store the ice cubes produced for long periods of time.
PROBLEMS WITH YOUR ICE MAKER?

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE
 ATTENTION 
1. Plug unit in.
2. Call for service.
3. Push the ON/OFF button to switch
unit on.
1. Open the drain hose to release some
water and then push the ON/OFF
button.
2. Call for service.
3. Add water
1. Take out the ice cubes from ice
re\servoir.
12
RESOLVING