Handle Assembly - Sears Kenmore 116.38412 Manual Del Propietário

Before assembling vacuum, check the
PACKING LIST on the cover of the separate
Repair Parts List. Use this list to verify that
you have received all the components of
your new Kenmore vacuum°
• WARNING
Electrical Shock Hazard
Do not plug Into the electrical sup-
ply until the assembly is complete.
Failure to do so could result in
electrical shock or injury.
HANDLE ASSEMBLY
Before assembling your vacuum cleaner
be sure you have all the parts shown.
Cord
Hooks
Hole
Opening
for Handle
Screw
Hole
Back of
Vacuum
Cleaner
Carry Handle
Screw
Remove the screw located just below the
carry handle on the back side of the
vacuum,
Position the handle so the cord hooks are
toward the back of the cleaner.
Insert the handle Into the opening at the
top of the vacuum.
Align the screw
hole in the handle
\
with the screw hole
in the vacuum°
Insert the screw so
Ill
it passes through
the back of the
vacuum into the
handle.
Begin to tighten Handle
the screw with your
Screw
fingers. It may be
Hole
necessary to
adjust the handle
slightly.
__ Carry Handle
/