Yamaha NS-3000 Manual De Instrucciones página 6

Diaphragms
Woofer rubber
surround
When using the optional Yamaha speaker stand (SPS-3000)
To use as floor stand speakers, attach the speakers to the SPS-3000 using
the holes at the bottom of the speakers.
For installation, also refer to the "SPS-3000 Owner's Manual".
Bottom of
speaker
100 mm
(3-7/8")
(Front)
Screw holes for
mounting onto
speaker stand
(Rear)
CAUTION
• Since the polished-finish side surfaces are slick,
hold the speaker from the sides and bottom to
carry it.
• When placing the speaker on the speaker stand,
etc., be sure not to pinch your hands or fingers.
NOTICE
• Be sure not to touch the diaphragms on the
front. Otherwise, they may be damaged.
• This unit is designed with a non-magnetic shield.
Placing this unit too close to a CRT TV set might
impair picture color or create a buzzing noise. In
this case, move the speakers away from the TV.
NOTE
• The particular type of rubber used for the woofer
surround was carefully chosen to contribute to the
best sound quality. In rare cases, this rubber may
turn an off-white color. Do not worry about this
whitening, since it is only a component of the
rubber penetrating to the surface, and will not
adversely affect performance.
Placing the speakers
Yamaha speaker
stand
SPS-3000
7