Sony VPL-SW536C Manual De Referencia página 64

3
Loosen the 2 screws on the lamp then
pull out the lamp by its grab.
4
Insert the new lamp all the way in until
it is securely in place. Tighten the
2 screws.
28
GB
Replacing the Lamp
5
Grab
6
7
Disposal of the used lamp
For the customers in the USA
Lamp in this product contains mercury.
Disposal of these materials may be
regulated due to environmental
considerations. For disposal or
recycling information, please contact
your local authorities or the
Telecommunications Industry
Association (www.eiae.org).
Close the lamp cover and tighten the
1 screw.
Note
Be sure to install the lamp securely as it
was. If not, the projector cannot be turned
on.
Connect the AC power cord to a wall
outlet and turn on the projector.
Reset the lamp timer for
the next replacement time.
Select "Lamp Timer Reset" on the
Function menu then press the ENTER
key. When a message appears, select
"Yes" to reset the lamp timer.
Caution
notification of