Control Mode - Sony FWD-S46H2 Manual De Instrucciones

Menu

Control Mode

Display+Remote
Display Only
Remote Only
Auto Screen Adjust
Auto Shut Off
DPMS
Overscan
Auto
On
Off
32
GB
Function and operation
Set to control the display from the remote control or from the display.
Note
When this item is operated, the available modes will differ depending on whether
you select by the remote control or the display. When setting this item with
button on the remote control, you can select only "Display+Remote" or "Remote
Only". When setting this item with
"Display+Remote" or "Display Only".
Enables operation of the display with the control buttons on the display and the
remote control.
Enables operation of the display with the control buttons on the display. You can
only use buttons on the display to enter this setting.
Enables operation of the display with the remote control. You can only use the
remote control to enter this setting.
Select "On" or "Off". If you select "On", it saves settings such as picture size and
position for each input signal, and the last settings are automatically applied.
Note
The "Auto Screen Adjust" function only works during RGB input.
Select "On" or "Off". When "On" is selected, the display automatically goes into
standby mode or power saving mode if no signal is input from the DVI, the HDMI,
the HD15 (RGB/COMPONENT) or the COMPONENT input connectors for about
30 seconds.
If no signal is input from the VIDEO connector for about 5 minutes, the display
automatically goes into standby mode.
Tips
• This function is available when "Screen Saver" is set to "Off".
• If "DPMS" is set to "On", you can select the settings for activating the power
saving mode.
Select "On" or "Off". When "On" is selected, the display automatically goes into
power saving mode if no signal is input from the DVI, the HDMI or the HD15
(RGB) input connectors for about 30 seconds.
When "Off" is selected, the display automatically goes into standby mode if no
signal is input from the DVI, the HDMI or the HD15 (RGB) input connectors for
about 30 seconds.
Tips
• While in the standby mode, press the 1 button on the display or the
on the remote control to turn the display on. In the power saving mode, the
display is turned on automatically when a signal is input.
• This function is available when "Screen Saver" is set to "Off".
• This function is available when "Auto Shut Off" is set to "On".
Selects whether to display images with overscan or justscan.
Automatically determines whether it is a DTV signal, then overscans and displays
the image.
Displays image with overscan.
Displays image with justscan.
Note
During DTV signal input, it may display a screen like when a PC signal is input.
Example: 480P → 720 × 480/60
button on the display, you can select only
ON button