Nilfisk-Advance SC401 Instrucciones De Uso página 17

(Only for drive versions) If necessary, adjust the maximum speed with the adjuster (47).
8.
9. To avoid marks or lines on delicate floors, use the "pre wetted" function, which dampens the brush before starting the
operation.
To activate this function, press the push-buttons (42) and (43) together for 10/20 seconds.
NOTE
The "pre wetted" function stays only as long as the push-buttons (42) and (43) are pressed.
10. Adjust the detergent flow by pressing the push-button (43) as necessary, depending on the type of cleaning to be performed.
When the LED is on, it indicates the value in liters per minute of solution flow supplied, as shown in the Figure 4. When the
LEDs are off, the solution flow is stopped.
11. If necessary, deactivate the vacuum system by pressing the push-button (44, LED off), then press it again to reactivate it (LED
on). To reduce the noise, turn on the vacuum system mute function by pressing the push-button (44).
12. (Only for no drive versions) If necessary, stop the machine and turn the forward speed adjusting handwheel (35) as shown
below:
• Turn it counter-clockwise to increase the forward speed;
• Turn it clockwise to decrease the forward speed.
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Advance suggests to go near the walls with the right side
of the machine as shown in figure 5.
CAUTION!
To avoid any damage to the floor surface, turn off the brush when the machine stops in one place.
09/2017
INSTRUCTIONS FOR USE
0.08 (0.3) 0.18 (0.7)
Figure 4
Figure 5
0.53 (2.0) gpm (l/min)
P100952
9100002290 - SC401
ENGLISH
P100953
15