Sony VPL-FHZ120L Manual De Referencia página 45

Connecting to a HDBaseT™ Device
The HDBaseT transmitter is used when connecting the projector to a computer, video device, or network
equipment.
Notes for connecting this unit to the HDBaseT transmitter
 Ask a professional or Sony dealer to perform wiring. If wiring has been insufficiently performed, it
affects the transmission characteristics of the cable, and causes broken or unstable images.
 Connect the cable directly to the HDBaseT transmitter without going through a hub or router.
 Use cables that meet the following conditions.
- CAT5e or higher
- Shielded type (covering connectors)
- Straight wire connection
- Single wire
When installing the cables, use a cable tester, cable analyzer, or similar device to check if the cables

meet the CAT5e or higher requirement. If there is a transit connector between this unit and the HDBaseT
transmitter, include it when measuring.
To reduce the affect of noise, install and use the cable in a manner where it is not rolled up and it is as

straight as possible.
 Install the cable away from the other cables (especially the power cable).
 When installing multiple cables, do not bind them and keep the running parallel distance as short as
possible.
 The transmittable distance of the cable is 100 m (approx. 328 feet) maximum. If it exceeds 100 m
(approx. 328 feet), it may cause broken images or a malfunction in LAN communication. Do not use the
HDBaseT transmitter beyond the maximum transmittable distance of the cable.
 For operation or function problems caused by devices of other manufacturers, contact the relevant
manufacturer.
Connecting to a computer/video device
INPUT E
Computer
Video device
HDMI output
terminal
HDMI cable
(not supplied)
HDMI output
terminal
LAN cable: STP cable with CAT5e or
higher (straight type) (not supplied)
HDBaseT transmitter
For information on other connecting methods,
refer to "Connecting the Projector" in the
Operating Instructions contained in the supplied
CD-ROM.
21
GB
Connecting