myaudioart MA5 Manual De Instrucciones página 22

Placing the fixing bolts
780 mm
55 mm 5 mm
For wall mounting, two fixing bolts must be used to carry the system.
Distance between the bolts: Landscape orientation 780 mm, portrait orientation 581 mm
For solid concrete walls, the provided screws and anchors can be used according
to the following instructions. If you use different bolts, make sure that those are not
thicker than 5 mm and have a bolt head diameter of no more than 12 mm. Otherwise
the system can not be safely mounted on them.
– Use a spirit level to mark both drill holes horizontally aligned and with the indicated
distance between them.
– Use an 7 mm concrete drill to drill two 55 mm deep holes.
– Insert the provided anchors up to the stop.
– Then, insert both the provided screws into the anchors and tighten them until the
distance between wall and head is 5 mm.
42
581 mm
110 mm 215 mm
User Manual
Hanging up the system
– If the system is to be mounted over the power socket, connect the IEC plug of the
mains cable to the socket on the rear of the system and the safety plug to the pow-
er socket. Set the toggle switch next to the socket so that it points toward the fabric
covering.
– Lift the system with the assistance of another person and adjust it above the bolts
in the wall.
– Place the system on one bolt first and then on the other while still supporting it.
– Then, let the system slowly slide down onto the bolts until it rests firmly on the bolts.
– When the system rests firmly on both bolts, release one side of the device first, then
the other.
– Check again that the system is securely fastened to the wall.
– If the system is mounted over the power socket, lay the mains cable in a zigzag line,
pull the system slightly off the wall and stow the mains cable in the clearance inside
the frame.
User Manual
43