Connecting To Video Equipment With Rgb Or S-Video Inputs - Sony DXC-390 Manual De Instrucciones

Basic System Connection

Connecting to Video Equipment with RGB or S-Video Inputs

CCDC-5/10/25/50A/100A cable or
CCMC-12P02/05/10/25 cable*
DC IN/VBS
DXC-390/390P
VIDEO OUT
DC IN/VBS
TRIG IN
LENS
MENU LOCK
OFF ON
RGB/SYNC
REMOTE
*If a CCMC cable is used, the S-video signal is also output from the S-video output of the CMA-D2/D2MD/D2CE/D2MDCE.
1) When using a video monitor without a sync signal input connector, the
camera can be set to output a sync signal with the G signal or RGB
signals.
For details, see "SYSTEM menu" on page 27.
50
(GB) Chapter 3 Installation and Connections
Camera cable: CCXC-9DB (D-sub 9-pin
y BNC connectors), or CCMC-9DS (D-
sub 9-pin y BNC, S-video connectors)
RGB/SYNC



or


Camera cable CCXC-9DD
(D-sub 9-pin y D-sub 9-pin)
1
Set the MODE selector
CMA-D2/D2MD/D2CE/
to the "1" position.
2
D2MDCE camera adaptor
CAMERA (4-pin or 12-pin)
R input
G input
B input
Sync input
Composite video (BNC) or
2)
S-video input (4-pin)
RGB/SYNC input
2) This setup is for connecting to a composite video (VBS) connector. To
output separated Y/C signals to the S-video input of video equipment,
use a CCMC-9DS camera cable.
For details on switching camera output between VBS (composite video) and
Y/C, see "SYSTEM menu" on page 27.
Power cord
RGB monitor,
image processor,
etc.
1)
Computer, image
processor etc.