Preset Tuning; Manual Preset Tuning - Yamaha TX-492 Manual De Instrucciones

MANUAL PRESET TUNING

This unit can store station frequencies selected by tuning operation. With this function, you can recall any desired station by only
selecting the preset station number where it is stored. Up to 40 stations (8 stations x 5 groups) can be stored.
* Parts in shaded area (
TX-492RDS only.
To store stations
1
Tune to a desired station.
(Refer to the previous page for tuning procedure.)
2
Select a desired group (A – E) of preset stations
confirming it on the display.
A/B/C/D/E
3
MEMORY
MAN'L/AUTO FM
4
Select a preset station number where you want to
program the station before "MEMO" goes off from the
display.
1
5
Shows the displayed station has been
programmed to A1.
* In the same way, program other stations to A2, A3 ... A8.
* You can program more stations to preset station numbers
on other groups in the same way by selecting other groups
in step 2.
10

PRESET TUNING

) are present on
MEMO
Flashes on and off
for about 5 seconds.
PRESET STATIONS
2 3 4
6 7 8
AUTO ST
MHz
4, 2 2
2, 1 1 3
To recall a preset station
1 1
Select the group of preset stations.
A/B/C/D/E
2 2
Select the preset station number.
1
5
Notes
•
A new setting can be programmed in place of the former
one.
•
For presets, the setting of the reception mode (stereo or
monaural) is stored along with the station frequency.
Memory back-up
The memory back-up circuit prevents the programmed data
from being lost even if the POWER switch is set off or the
power plug is disconnected from the AC outlet or the power is
cut due to temporary power failure. If, however, the power is
cut for more than one week, the memory may be erased. If
so, it can be re-programmed by simply following the PRESET
TUNING steps.
PRESET STATIONS
2 3 4
6 7 8