Tuning Operations; Automatic Tuning; Manual Tuning - Yamaha TX-492 Manual De Instrucciones

Normally, if station signals are strong and there is no interference, quick automatic-search tuning (AUTOMATIC TUNING) is
possible. However, if signals of the station you want to select are weak, you must tune to it manually (MANUAL TUNING).
1
* Parts in shaded area ( ) are present on
TX-492RDS only.

AUTOMATIC TUNING

1
Turn the power on.
2
Select the reception band confirming it on the display.
TX-492RDS
FM/MW/LW
TX-492
FM/AM
3
TUNING MODE
AUTO/MAN'MONO
4
TX-492RDS
TUNING
DOWN UP
PTY SELECTOR
To tune to a higher frequency, press the UP button.
To tune to a lower frequency, press the DOWN button.
* If the station where tuning search stops is not the desired
one, press again.
* If the tuning search does not stop at the desired station
(because the signals of the station are weak), change to
the MANUAL TUNING method.

TUNING OPERATIONS

POWER
, or
or
AUTO
TX-492
TUNING
DOWN UP
2 3

MANUAL TUNING

1
Turn the power on.
2
Select the reception band confirming it on the display.
TX-492RDS
FM/MW/LW
TX-492
FM/AM
3
TUNING MODE
AUTO/MAN'MONO
4
Tune to a desired station manually.
TX-492RDS
TUNING
DOWN UP
PTY SELECTOR
* To continue tuning search, press and hold the button.
Notes
•
If you tune to an FM station manually, it is received in
monaural mode automatically to increase the signal quality.
TX-492RDS only
•
When tuned in to a station, the frequency of the received
station is shown on the display. If an RDS station that
employs PS data service is received, the frequency is then
replaced by the station name. Refer to page 15 for details.
4
POWER
, or
or
Turn "AUTO" off.
TX-492
TUNING
DOWN UP
9