Maintenance; Maintenance Schedule; To Clean And Lubricate The Blades; To Lubricate The Gear Housing - Husqvarna RA850 Manual De Usuario

4. Pull the attachment straight out of the coupling.
C
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.

Maintenance schedule

Below is a list of the maintenance steps that must be
done on the cutting attachment.

Maintenance

Clean the external parts of the product.
Make sure that the blades are not damaged. Replace the blades if they are dam-
aged.
Make sure that the cutting attachment guard is not damaged. Replace the cut-
ting attachment guard if it is damaged.
Make sure that the support cup is not damaged. Replace the support cup if it is
damaged.
Make sure that the screws and nuts are tight.
Fill the gear housing with grease, approximately each 100 work hours.

To clean and lubricate the blades

1. Clean the blades from unwanted materials before
and after you use the product.
2. Lubricate the blades before long periods of storage.
Note: Speak to your servicing dealer for more
information about recommended cleaning agents and
lubricants.

To lubricate the gear housing

CAUTION: Do not fill the gear housing fully.
If the gear housing is full, the grease can
1050 - 002 - 12.04.2019
Maintenance
Note: The operator must only do the maintenance and
service on the cutting attachment that is given in this
operator's manual. Other maintenance and service must
be done by an approved service workshop.
1. Remove the grease plugs.
Daily Weekly
X
X
X
X
X
cause damage to the seals and cause
leakage.
Monthly
X
9