Installing The Speakers - Yamaha DVX-S100 Manual De Instrucciones

SPEAKER SETUP

Installing the speakers

I Placing the center speaker
Place the speaker on TV whose top is flat or on the floor
under the TV or inside the TV rack so that it is stabilized.
When placing the speaker on top of the TV, to prevent the
speaker from falling down, put the provided fasteners at
four points on the bottom of the speaker and the top of the
TV.
Peel off the
seal
Cautions
• Do not place the speaker on top of the TV whose area is
smaller than the bottom area of the speaker. If placed, the
speaker may drop out causing an injury to you.
• Do not place the speaker on top of the TV with an inclination.
• Do not touch the adhesive surface after peeling off the seal as
this will weaken its adhesive strength.
• Thoroughly wipe clean the surface where the fastener is to be
applied. Note that adhesive strength is weakened if the surface
is dirty, oily or wet and that this may cause the center speaker
to drop.
I Placing the front and rear
speakers
When placing the front and rear speakers on a flat
surface, attach the included non-skid pads to the corners
on the bottom of the speakers as shown below. This
prevents the speakers from sliding around.
12
Fastener
Non-skid pads
I Mounting the front and rear
speakers
When mounting the front and rear speakers on a wall, use
the holes on the speakers' back panels.
1
Put the provided pads at the four corners on
the rear of the front and rear speakers to
prevent the front and rear speakers from
moving by vibrations.
2
Fasten screws into a firm wall or wall
support as shown below.
Diam. 3.5 to 4 mm
Min.
20 mm
6 mm
Tapping screw
(Available at the
hardware store)