Changing The Dust Bag - Bosch BHS4 Serie Instrucciones De Uso

11
Figure
a) The vacuum cleaner can be hung by the handle for
storage.
b) The vacuum cleaner can be transported by the carrying
handle.

Changing the dust bag

Replacing the dust bag
It is necessary to change the dust bag if the dust bag
change indicator appears full when the nozzle is lifted from
the floor.
12
Figure
Open the lid in the direction of the arrow, lift it away from
the vacuum cleaner and put it to one side.
13
Figure
Seal the dust bag by pulling the sealing tab, remove the
dust bag and insert a new one.
!
Caution: The lid only closes with a dust bag inserted.
After using the vacuum cleaner for fine dust particles
(such as plaster or cement), clean the micro filter and
replace it if necessary.
If the dust bag change indicator still appears full
following the dust bag change, it may be because the
rotary knob is blocked.
14
Figure
a) Press the rotary knob to release it and turn it to the
position of the arrow.
Remove the rotary knob and shake it
b) Refit the rotary knob and, while pressing it down, turn it
back to the vacuum position required.
Replacing the micro-hygiene filter
Replacement is required:Each time you need to open the
replacement filter pack.
15
Figure
Open the lid (see Figure 12).
Pull out the filter holder and open it.
Dispose of the micro-hygiene filter and fit a new micro-
hygiene filter.
Insert the filter holder back into the vacuum cleaner and
close the lid
Replacing the HEPA filter
If your vacuum cleaner is equipped with a HEPA filter, this
should be replaced once a year.
16
Figure
Open the lid (see Figure 12)
Remove the old HEPA filter from the appliance
Insert the new HEPA filter into the vacuum cleaner and
close the lid.
80
Care
Always switch the vacuum cleaner off and disconnect the
power cord from the mains before cleaning the vacuum
cleaner.
The vacuum cleaner and plastic accessories can be
cleaned with a commercial plastics cleaner.
!
Do not use abrasive, glass or all-purpose cleaners.
Never immerse the vacuum cleaner in water.
The dust compartment can, if necessary, be cleaned with a
second vacuum cleaner or simply wiped with a dry cloth or
a duster.
Subject to technical changes.