Connecting The Power Cord - Pioneer ELITE PRO-FHD1 Manual De Instrucciones

Preparation
06

Connecting the power cord

CAUTION
• Use only the supplied power cord.
• Be sure to use the specified power supply voltage;
neglecting this can result in fire or electric shock.
• For the Plasma Display, a three-core power cord
with a ground terminal is used for efficient
protection. Always connect the power cord to a
three-pronged outlet and make sure that the cord
is properly grounded.
NOTE
• Always turn off the power of the Plasma Display when
connecting or disconnecting power cords.
• When not using this unit for extended periods, disconnect
the power cord from its outlet.
18
En
AC IN
SPEAKER
8Ω ~16Ω
+
Power cord
Noise filter
Partially eliminates noise caused by the power source.
L
–
Connecting the speakers
This unit is equipped with speaker output terminals. Consult
the accompanying illustration when connecting your own
speakers.
NOTE
• When connecting speakers, be sure to connect the
speaker's positive (+) and negative (–) terminals to the same
terminals on this unit. Proper sound will not be produced if
the (+) and (–) polarities are not connected correctly.
• This unit supports the use of speakers with 8 Ω to 16 Ω
impedance.
Twist exposed wire
strands together.
Push tab to the open
position, and insert the
wire. Then, close tab firmly
to secure the wire in place.