Monogram ZV48SSJSS, ZV36SSJSS, ZV30SSJSS Manual Del Propietário página 34

Stainless
steel
surfaces
(on some
models)
Light bulbs
Warming
lamps
10
Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always
wipe the surface in the direction of the grain. Follow
the cleaner instructions for cleaning
the stainless steel surface.
To change the light bulbs:
1. Grasp the outer trim ring and twist until
reaching the unlock position. Then pull the ring
straight out.
2. Grasp the bulb and twist until reaching the
unlock position. Then gently pull the bulb
straight out.
3. Replace with the same wattage, type and size
bulb. Wear gloves. Do not touch bulb with your
bare fingers.
These 120 volt, 50 watt halogen bulbs with a
GU10 base are available at specialty lighting
stores and home building centers.
Order bulb no. WB08X10052.
4. Replace the outer trim ring by inserting the two
retaining tabs into the two tab slots, pressing
the ring flush with the surface of the hood insert
and twisting until reaching the lock position.
The warming lamps are located on the underside
of the hood.
These 120 volt, 175 watt, par 38 infrared heat
lamp bulbs, with standard base, are available
at some specialty lighting stores.
These infrared bulbs can also be ordered
from your GE supplier.
Order bulb no. WB08X10029.
Care and Cleaning
Professional Vent Hood
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the location
of a dealer nearest you, please call our toll-free
number:
National Parts Center
GEApplianceParts.com
NOTE: If warming lamps are not desired,
additional cooktop lighting can be obtained
by replacing the infrared bulbs with standard
incandescent bulbs with up to 100 watt
maximum ratings, with standard bases. These
bulbs are available at specialty lighting stores.
1.800.626.2002