Care And Cleaning; Cleaning The Outside; Cleaning The Condenser - GE UCC15 Manual Del Propietario E Instalación

Care and cleaning.

Cleaning the Outside

The stainless steel door and door handle can be cleaned with
a commercially available stainless steel cleaner. Cleaners with
oxalic acid such as Bar Keepers Friend Soft Cleanser™ will
remove surface rust, tarnish and small blemishes.
Cleaning the Ice Storage Bin
The ice storage bin should be sanitized occasionally. It is usually
convenient to sanitize the bin after the ice making system has
been cleaned and the bin is empty.

Cleaning the Condenser

The condenser has fins and tubes that can become clogged
with dirt and lint.
NOTE: Outdoor operation can lead to rapid buildup of debris,
such as leaves and other vegetation. The condenser will need
to be frequently checked for debris. Clean it whenever the fins
are obstructed.
To clean:
1. Remove the kickplate and front service panel.
2. Locate the condenser surface.
Condenser surface
Winterizing
1. Clean the ice making system per the instructions above.
2. Open the door. Push the ON/OFF button to turn the ice
machine off.
3. Turn off the water supply.
4. Drain the water reservoir by removing the rubber stopper
under the reservoir. It is located near the back wall of the ice
storage bin.
6
Rubber stopper
Use only a liquid cleanser free of grit and rub in the direction of
the brush lines with a damp soft sponge. Do not use appliance
wax or polish on the stainless steel.
A sanitizing solution can be made of 1 oz of household bleach
and 2 gallons of hot (95°F - 115°F) water. Use a clean cloth
and wipe the interior of the ice storage bin with the sanitizing
solution. Pour some of the solution down the drain.
Allow to air dry.
3. Vacuum the surface to remove all dust, dirt, and lint.
NOTICE
Do not dent the fins.
4. Return the kickplate and front service panel to their original
positions. Fasten them to the cabinet using the original
screws.
5. Disconnect the incoming water line at the inlet water valve.
6. Open the door. Push the ON/OFF button to turn the ice
machine on.
7. Blow air through the inlet water valve. A tire pump can be
used.
8. Models with a drain pump installed should have about 1/2
gallon of RV antifreeze (propylene glycol) poured into the ice
storage bin drain.
NOTE: Automotive antifreeze must NOT be used.
9. Turn off and unplug the machine.