Service Schedule; Daily Maintenance - Husqvarna FS7000 DL Manual De Instrucciones

Service schedule

The service schedule is based on the machine's operating time. More frequent service intervals might be necessary when working
in dusty or hot environments and in conjunction with work that generates high temperatures. A description of how the operations
are to be performed is to be found in the service review.
For certain service requirements, refer to the service intervals in the service schedule below and keep track on the next service.
The machine will keep track on the working hours and it can be seen in the display.
• Always park the machine on a level surface with the engine OFF and the Engine start switch set in the STOP position before
performing any maintenance. Press the Machine stop on the control panel.
Please read the engine manual for your machine carefully and make sure you understand the instructions before using the
machine. There are some maintenance intervals specified in the engine manual.
In case where same services operation is recommended both in this machine's operator manual and in the engine operator
manual, follow the schedule recommendations given in this manual.

Daily Maintenance

Daily maintenance must also be carried out after transportation.
Check radiator coolant level.
Check the engine's oil level
Check blade guard for damage
Check hoses and clamps for damage or looseness. Tighten or
replace as required.
Check air cleaner restriction indicator. Clean outer air filter if
indicator is red.
Make sure all safety guards are in place and in good condition.
Drain cooling water from gearbox to prevent rust and/or freeze
damage.
Check the water spray over the diamond blade.
Drain fuel filter water separator from water
Lubricate hydraulic cylinder pivot pin.
Replace engine oil and filter*
Check and clean radiator air filter or replace if necessary.
Check blade drive V-belt tension (first time after 2 hours).Tension
both side evenly. Do not over tension
Lubricate front wheels
Replace hydraulic system filter**
Replace engine oil and filter*
Lubricate front axle pivot bearings
Check wheels for wear or damage.
Check rear wheel hubs and wheels for looseness
Check engine air cleaner hose and clamps
Check hydraulic system fluid level
Replace hydraulic system filter**
Lubricate blade shaft (2 pumps each end)
Lubricate rear axle bearing.
Replace engine gearbox fluid
Replace hydraulic system fluid
Replace engine fuel filter (spin-on-type)
Flush and clean radiator and cooling system
Replace outer and inner air filter
Check coolant freeze protection
* Once at 50h then every 100h
** Once at 50h then every 250h
34 –
English
MAINTENANCE AND SERVICE
Daily 50h 100h
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
250h 500h Yearly
X
X
X
X
X
X
X
X
X