Husqvarna FS7000 DL Manual De Instrucciones página 38

Check engine air cleaner hose and clamps
The image only shows some of the hoses and clamps.
Check hydraulic system fluid level
• Remove the plug in the inspection opening on the
hydraulic reservoir. The level should be to the bottom edge
of the opening on the hydraulic reservoir, fill if necessary.
NOTICE! Do not overfill!
Lubricate front axle pivot bearings
See instructions under the heading "Lubrication".
250 hours service
Replace the hydraulic system filter.
See instructions under the heading "After the first 50 hours"
Lubricate blade shaft (2 pumps each end)
See instructions under the heading "Lubrication".
Lubricate hydraulic cylinder pivot pin.
See instructions under the heading "Lubrication".
Lubricate rear axle bearing.
See instructions under the heading "Lubrication".
500 hours service
Replace engine gearbox fluid
Select one of the following options to drain gearbox fluid:
Option 1
38 –
English
MAINTENANCE AND SERVICE
• Open the window by removing the plug and suck the oil
out with an oil extractor.
Option 2
• Slip a vessel under the bell housing of the engine. Loosen
the screw and drain the oil. Once the system is empty,
fasten the screw.
• Refill the system by removing the left screw and pour oil
into the tube. Look in the window and fill until the correct
level is reached.
• Refit the screw and follow the steps in reverse order.