Husqvarna FS7000 DL Manual De Instrucciones página 43

Circuit short to
C1D0615 Water pump
battery or open
Circuit short to
C1D0611 Water pump
ground
Circuit short to
C1D0915 Working light
battery or open
Circuit short to
C1D0911 Working light
ground
Circuit short to
C1D0C15 Ignition
battery or open
Circuit short to
C1D0C11 Ignition
ground
Hydraulic lift Circuit short to
C1D0D15
pump battery or open
Hydraulic lift Circuit short to
C1D0D11
pump ground
Hydraulic
Circuit short to
C1D0E15 lowering
battery or open
valve
Hydraulic
Circuit short to
C1D0E11 lowering
ground
valve
E-track
Circuit short to
C1E0511 position
ground
sensor
E-track
Circuit short to
C1E0512 position
battery
sensor
TROUBLESHOOTING
Check K2 in relay/fuse box.
Water pump can not
be controlled by the
Check damage to X14 connector, harness to relay/fuse
HMI. May not be
box and relay/fuse box connector. If found, repair and
able to turn on.
restart system, reset fault code.
Water pump can not If problem still exists, contact your service agent for further
be turned on. information.
Check working light relay K3 in relay/fuse box.
Working light can Check damage to X14 connector, harness to relay/fuse
not be controlled by box and relay/fuse box connector. If found, repair and
the HMI. May not be restart system, reset fault code.
able to turn on.
If problem still exists, contact your service agent for further
information.
Yanmar:
Check K8 in relay/fuse box.
Check damage to X14 connector, harness to relay/fuse
box and relay/fuse box connector. If found, repair and
restart system, reset fault code.
Also check the machine stop (X33) and X30.
Engine can not be
If problem still exists, contact your service agent for further
started.
information.
Deutz:
Check damage to X14 and X1 connector and harness. If
found, repair and restart system, reset fault code.
If problem still exists, contact your service agent for further
information.
Check K6 in relay/fuse box.
Hydraulic lift pump
Check damage to X14 connector, harness to relay/fuse
can't be used for
box and relay/fuse box connector. If found, repair and
raising the blade.
restart system, reset fault code.
Hydraulic lift pump
If problem still exists, contact your service agent for further
can't be used for
information.
raising the blade.
Check that hydraulic valve is properly connected.
Check damage to X14 connector, harness and hydraulic
valve. If found, repair and restart system, reset fault code.
Hydraulic lowering
If problem still exists, contact your service agent for further
valve can't be used
information.
for lowering the
Check damage to X14 connector, harness and hydraulic
blade.
valve. If found, repair and restart system, reset fault code.
If problem still exists, contact your service agent for further
information.
Check damage to actuator, connector and harness. If
Cutting can
found, repair and restart system, reset fault code and
continue but E-track
recalibrate.
position can not be
detected until fault
If problem still exists, contact your service agent for further
is resolved.
information.
– 43
English