To Clean The Product; To Do A General Inspection; To Clean The Battery And The Battery Charger - Husqvarna PG 690 Manual Del Usuario

Maintenance
Do a check of the ON/OFF switch on the control panel.
Do a check of the STOP/RUN switch on the remote control.
Do a check of the emergency stop button on the control panel.
Do a check of the emergency stop button on the remote control.
Do a check of the attachment points and the lock function for the handle.
Do a check of the attachment points and the lock function for the weights.
Clean the external surfaces of the product.
Clean the internal components of the product.
Do a general inspection.
Do a check of the grinding discs.
Do a function check of the drive system for the grinding head.
Do the service on the drive system for grinding discs.
Do a check of the connection between chassis and grinding head.

To clean the product

CAUTION: A blocked air intake decreases
the performance of the product and can
cause the motor to become too hot.
• Remove blockage from all air openings. The product
must always have sufficiently cool temperature.
• Always disconnect the power plug from the mains
outlet before you clean.
• Do not use chemicals to clean the product.
• Do not clean electrical components with water.
• Always clean all the equipment at the end of the
work day.
a) Tilt the product until the handlebar is on the floor.
b) Remove the diamond tools and operate the
product for a short period at the lowest speed.
Operate the product to decrease the quantity of
dust at the top surface of the grinding head.
c) Clean the components at the bottom surface of
the grinding head with a high-pressure washer.
CAUTION: Do not point the high-
pressure washer directly at seals or
connection points.

To clean the battery and the battery charger

CAUTION: Do not clean the battery or the
battery charger with water.
34
Daily
*
*
X
X
X
X
X
• Make sure that the battery and the battery charger
are clean and dry before you connect the battery into
the battery charger.
• Clean the battery terminals with compressed air or
use a soft and dry cloth.
• Clean the surfaces of the battery and the battery
charger with a soft and dry cloth.

To do a general inspection

• Make sure that the power cord and extension cable
are in good condition and not damaged.
• Make sure that nuts and screws are tight.
• Make sure that the head locks are tight. If it is
necessary, tighten the head locks and use
®
LOCTITE 680 threadlocker.
Each
Each 6
Weekly 12-36
months
months
*
*
O
X
*
1163 - 003 - 22.01.2020
O