Troubleshooting Schedule; Troubleshooting - Husqvarna Soff-Cut 150 Manual Del Usuario

Troubleshooting schedule

WARNING: Troubleshooting causes risk of
injury because personnel does work in the
Problem
The product is spalling and
ravelling cut (Soff-Cut 150)
714 - 002 - 09.04.2018

Troubleshooting

Solution
Check to see if the diamond blade is worn out, glazed, warped or damaged.
Ensure skid plate moves freely up and down the entire shaft length without contacting
the diamond blade.
Check skid plate for excessive wear or gap around the diamond blade.
Check bottom of skid plate for metal burrs or irregularities.
Ensure skid plate is not twisted or bent.
Check lexan covers for free movement up and down.
Ensure there is spring down pressure at each end of the skid plate.
Do not twist or move the product sideways while cutting. Make gradual changes in
pressure on the handlebar to control the saw in the cut.
Check that the engine is running properly and at full throttle.
Check belt and belt idler for proper tension.
Ensure the diamond blade is properly mounted and secured with clean flanges.
Ensure that the diamond blade is the correct specification for your area.
Ensure the slab is in clean with no debris that could raise the skid plate or product
while cutting.
Use Husqvarna joint protectors at all cut intersections.
Clean excess concrete debris from the blade block assembly.
Check that the scrapers in the blade block are not bent or binding.
Ensure that the blade block shafts are not bent or damaged.
risk areas of the product. Be careful, prepare
the work and use common sense.
If you cannot find a solution to your problems in this
owner's manual, speak to your Husqvarna service
agent.
17