To Do A Check Of The Parking Brake; To Clean And Replace The Air Filter; To Replace The Fuel Filter - Husqvarna R 418Ts AWD Manual De Usuario

5. Put the new lamp into the lamp housing. Keep your
thumb on the front of the lamp. Use the type of lamp
Technical data on page 35 .
as given in
6. Connect the cables to the new lamp.
7. Put the lamp housing back, attach the cover of the
servo housing and tighten the screws.

To do a check of the parking brake

1. Park the product on a hard surface that slopes.
Note: Do not park the product on a grass slope when
you do a check of the parking brake.
2. Press the parking brake pedal down (1).
3. Press and hold the lock button (2) and release the
parking brake pedal while the button is pressed.
1
4. If the product starts to move, let an approved service
agent adjust the parking brake.
5. Press the parking brake pedal again to release the
parking brake.

To replace the fuel filter

1. Open the engine cover to access the fuel filter.
2. Move the hose clips away from the fuel filter with a
pair of flat pliers.
3. Pull off the fuel filter from the hose ends.
22
2
4. Press the new fuel filter into the ends of the hoses.
Apply liquid detergent to the ends of the fuel filter to
make the connection easier.
5. Push the hose clips against the fuel filter.

To clean and replace the air filter

1. Open the engine cover.
2. Loosen the knobs that hold the air filter cover and
remove it.
3. Lift out the air filter.
4. Remove the foam rubber filter around the air filter
cartridge.
5. Clean the foam rubber filter with a weak detergent.
6. Let the foam rubber filter become fully dry.
7. Hit the paper filter against a hard surface to clean it.
Do not use compressed air.
8. If the paper filter does not become clean, replace it.
9. Put the foam rubber filter back around the air filter
cartridge.
522 - 002 -