14
OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating
the device.
14.1
Operation instructions
Perform all machine settings with the machine being
The safety screw on the grinding wheel must be removed before
operation!
HOLZMANN MASCHINEN GmbH
WARNING
disconnected from the power supply!
Before first operation test buttons 3, 4, 7 and 9 on the control
panel to ensure the correct direction.
Adjust the position of the travel grinding adjustment
according to the length of the grinding tool.
Use diamond pen to sharpen the grinding wheel, so as to
avoid the grinding wheel being sealed and affect the grinding
quality.
The grinding wheel should be replaced timely when it is worn
to a certain extent.
The grinding wheel should parallel the cutter rest. The cushion
should be fixed on both sides of the grinding wheel when it is
clamped so as to prevent the grinding wheel from being
squeezed to rupturing.
Make sure that enough cooling
www.holzmann-maschinen.at
ATTENTION
NOTICE
OPERATION
26
HMS 700 / HMS 1000