Features; Product Specifications; Assembly - RIDGID R3205 Manual Del Operador

Sierra circular de 184 mm (7-1/4 pulg.)
Ocultar thumbs Ver también para R3205:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FEATURES

PRODUCT SPECIFICATIONS

Blade Diameter ......................................................7-1/4 in.
Blade Arbor .............................................................. 5/8 in.
Cutting Depth at 0° ................................................2-3/8 in.
Cutting Depth at 45° ..............................................1-3/4 in.

ASSEMBLY

UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Do not use this product if any parts on the Includes
List are already assembled to your product when
you unpack it. Parts on this list are not assembled
to the product by the manufacturer and require
customer installation. Use of a product that may
have been improperly assembled could result in
serious personal injury.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of
this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this
product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly
is complete. Failure to comply could result in
accidental starting and possible serious personal
injury.
Cutting Depth at 56° ..............................................1-3/8 in.
No Load Speed .................................... 5,800 r/min. (RPM)
Input ................................120 V, 60 Hz, AC only, 15 Amps
ATTACHING THE BLADE
See Figure 1, page 15.
WARNING:
7-1/4 in. blade is the maximum blade capacity of
the saw. Also, never use a blade that is too thick
to allow outer blade washer to engage with the
flat on the spindle. Larger blades will come in
contact with the blade guides, while thicker blades
will prevent blade screw from securing blade on
spindle. Either of these situations could result in a
serious accident.
 Unplug the saw.
 Remove the blade wrench (6 mm hex key) from the
storage area.
 Depress the spindle lock button and remove the blade
screw and outer blade washer ("D" washer).
NOTE: Turn the blade screw counterclockwise to remove.
NOTICE:
To prevent damage to the spindle or spindle lock,
always allow motor to come to a complete stop
before engaging spindle lock.
NOTE: Do not run the circular saw with spindle lock engaged.
 Wipe a drop of oil onto the inner flange bushing and outer
blade washer ("D" washer) where they contact blade.
WARNING:
If inner flange bushing has been removed, replace
it before placing blade on spindle. Failure to do
so will prevent blade from tightening properly and
could result in serious personal injury.
 Retract the lower guard into the upper guard, making
sure the lower guard spring works properly, allowing the
guard to move freely.
 Check to see that the saw teeth and arrow on the saw
blade and the arrow on the lower guard are pointing in
the same direction.
7 — English

Publicidad

Tabla de contenido
loading

Tabla de contenido