Set-Up; Charging Instructions; Trap Placement - Mosquito Magnet Executive Manual De Instrucciones

Charging Instructions

1. Remove cover panel from rear of Power Head Unit (panel
snaps off). Press the battery latch & pull out of the trap to
disconnect. Remove the battery by pulling up on the bottom
and rotating the battery out of position.
2. The Battery Charger is not rated for Outdoor use. The battery
must be charged indoors.
3. Plug the Battery Charger into a suitable indoor outlet.
4. Connect the re-chargeable battery to the battery charger.
5. The LED on the Battery Charger will indicate Red when the
battery is charging, when the battery is fully charged the LED
will indicate Green. The typical charge time is less than two
hours.
6. The battery charger is automatic, it will shut down to a safe
maintenance charge current when the battery is fully charged.
It will not over charge the battery. For maximum life, do not
leave the battery on the charger for extended periods.
7. When the battery is fully charged, disconnect the battery from
the battery charger and return it in the Mosquito Magnet
Executive.
8. Insert and connect the re-chargeable battery.
9. Replace the cover panel on the rear of Power Head Unit.

Trap Placement

1. Determine the direction of the prevailing wind.
Check local weather patterns if you are unsure.
2. Stand in the center of the area you are trying to protect
and look toward the prevailing wind.
3. Proper placement of the trap will be 30 – 40 feet
in front of you, within 5-6 feet of ground cover (i.e. bushes,
flowerbeds, tree line, marshbed). Ensure that trap is not
directly against any blockades such as buildings, fences, etc.
4. It is recommended that the trap be placed in the shade.
5. Do not place trap directly above a water source
(sprinklers, hose, etc.).
6. Trap must be placed on level ground to avoid tipping
or uneven propane distribution.
7. For optimal trap placement in your yard, refer to the
instructional video at www.mosquitomagnet.com/videos to
build your own yard diagram for correct trap placement.

Set-Up

Remove Back Panel
Insert & Connect Battery
8