Safety Instructions - Mosquito Magnet Executive Manual De Instrucciones

Ocultar thumbs Ver también para Executive:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Safety Instructions

Please read and follow all safety
instructions and warnings.
Children and adults should be alerted to
the hazards of high surface temperatures
and should stay away to avoid burns or
clothing ignition.
Young children should be carefully
supervised when they are in the
area of the heater. Keep out of
reach of children.
Clothing or other flammable materials
should not be hung from the heater,
or placed on or near the heater.
Note:
Some or all of the following required safety
instructions for propane powered devices may
apply to your trap. Allow trap to cool for 5 minutes
before re-starting.
Warning:
Improper installation, adjustment,
alteration, service or maintenance can cause injury
or property damage. Read the installation, operating
and maintenance instructions thoroughly before
installing or servicing the trap.
Caution:
The gas pressure regulator provided with this
appliance must be used. This regulator is set for an outlet
pressure of 11.0 in. Water Column. The minimum inlet gas
supply pressure is 11.0 in. Water Column from regulator.
This unit is not intended to be installed in or on recreational
vehicles and/or boats.
The gas supply must be turned off at the LP-Gas supply
cylinder when this appliance is not in use.
The installation must conform with local codes or, in the
absence of local codes, with the National Fuel Gas Code,
ANSI Z223. 1-1998 for US and with the CAN1-B149 for Canada.
To test for a gas leak, place soapy water around the
connector, regulator, and gas hose assembly. If bubbles
appear, there is a gas leak.
Inspect the hose before each use of the unit. If it is evident there
is excessive abrasion or wear, or the hose is cut, it must be
replaced prior to the unit being put into operation. The
replacement hose shall be that specified by the manufacturer.
The trap is equipped with an internal spark ignition device. Failure
to follow starting procedure will result in the trap not starting.
Installation and repair should be done by a qualified service
person (find service centers on www.mosquitomagnet.com).
The heater should be inspected before use and at least
annually by a qualified service person. More frequent
cleaning may be required as necessary. It is imperative that
the control compartment, burners, and circulating air
passageways of the heater be kept clean.
4

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido