Using The Controls - Lower Tumble Dryer - Maytag NEPTUNE 2206670 Guía De Uso Y Cuidado

U U C
SING THE ONTROLS
Step 1 Select a Cycle
Select the dry cycle by pressing the appropriate pad.
Sensor Dry – automatically senses the moisture in the load and shuts
the dryer off when the selected dryness level (very dry to damp dry) is
reached.This cycle is recommended for the majority of loads including
delicates, wrinkle-free and cotton/sturdy items like towels, bedding and
jeans.
Time Dry – may be selected for any load if Sensor Dry is not used. Press
the or time pad to select the desired number of minutes.
Wrinkle Release – will release wrinkles from items that are clean and
dry but slightly wrinkled, such as from a crowded closet, packed suitcase or
from sitting in the dryer too long after the end of the cycle. It provides 8
minutes of heated tumbling and 10 minutes of cool down tumbling without
heat.
Air Fluff/No Heat – tumbles in room temperature air. Press the
time pad to select the desired number of minutes.
Step 2 Select the Temperature
There are four temperature settings. Press the
or Extra Low temperatures.
Regular – for sturdy cottons or those labeled "Tumble Dry." Approximately 150° F.
Medium – for permanent press, synthetics, lightweight cottons or items labeled
"Tumble Dry Medium." Approximately 145° F.
Low – for heat sensitive items labeled "Tumble Dry Low" or "Tumble Dry Warm."
Approximately 140° F.
Extra Low – provides the lowest heated dry temperature possible for very delicate
or hand wash items. Approximately 125° F.
Step 3 Select Dryness Level
When Sensor Dry is selected, use the
select the dryness level. When Time Dry is selected, use the
and pads to set drying time in one minute increments.
Hold the or pads to increase or decrease time rapidly.
Very Dry – used to completely dry sturdy or bulky items
including towels and jeans.
More Dry – used for drying t-shirts, underwear and socks.
Normal Dry – used for drying the majority of loads.
Damp Dry – designed to partially dry items.
- L T
OWER UMBLE
pad to select Regular, Medium, Low
and pads to
9
D
RYER
or