Clutch Adjustment - Ingersoll Rand QP Serie Especificaciones Del Producto

EN

Clutch Adjustment

Turn off the air supply and disconnect the air supply hose from the Tool before proceeding.
1. Unscrew the Clutch Adjusting Hole Cover far enough to expose the clutch adjusting hole in
the Clutch Housing.
2. Insert a 1/4" hex wrench into the Bit Holder and rotate the clutch mechanism until the
area having an opening between the faces of the Clutch Adjusting Nut Washer and Clutch
Adjusting Nut is visible.
3. Using a screwdriver that has a #1 Phillips tip, insert the tip of the screwdriver into the
opening and rotate the screwdriver to adjust the Clutch. Rotate the screwdriver clockwise to
decrease Clutch Spring tension and torque and counterclockwise to increase the tension and
torque.
The most satisfactory adjustment is usually obtained by using the tool on the actual
application and increasing or decreasing the delivered torque until the desired setting
is reached. In any event, it is recommended that final adjustment be made by gradual
progression.
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN-2
WARNING
NOTICE
80165939_ed4