Product Description; Product Specifications; Torque Adjustment - Ingersoll Rand ES45T Especificaciones Del Producto

EN

Product Description

Intended Use:
These hand-held electric tools are designed for threaded joint fastening applications.
• Do not adjust the torque setting higher than 5 on the Torque Scale.
For additional information refer to Hand-held Electric Angle Wrench, Screwdriver or Nut
Runner used with a Controller Product Safety Information Manual Form 16573685.
Manuals can be downloaded from www.irtools.com

Product Specifications

Torque Range
Model
Number
in-lbs.
ES45T 0.3 - 6.5 0.03 - 0.73 600 - 900
ES50T 0.5 - 9.0
ES50TC 0.5 - 9.0

Torque Adjustment

To adjust the torque on these screwdrivers, proceed as follows:
1. Determine the torque output of the tool by checking a tightened fastener with a torque
wrench.
2. Increase or decrease the torque output by rotating the Spring Adjusting Ring. Rotating
the Ring clockwise to a higher number on the Torque Scale increases torque output while
rotating the Ring counterclockwise to a lower number decreases the torque output.
The numbers on the Torque Scale are reference numbers only and are not an indication of
actual torque output.
3. Check the adjustment with a torque wrench. A number of factors will affect torque output
from one job to another. Final torque adjustment should be made at the job through a series
of gradual increases. Always start below the desired torque and work upward.
EN-1
WARNING
Free
Speed
Nm (RPM)
0.05 - 1.0 500 - 650
0.06 - 1.0 500 - 650
NOTICE
Weight Length Bit Size Duty Cycle
(lbs.) (in.) (in.)
0.75 8.87 0.25
0.75 8.88 0.25
0.88 10.5 0.25
Controller
(On/Off)
0.5/3.5 ESCB50
0.5/3.5 ESCB50
0.5/3.5 ESCB50
45527702_ed1