Assembly - Craftsman 580.754902 Instrucciones De Uso

Your pressure washer requires some assembly and is
ready for use only after it has been properly serviced
with the recommended oil and fuel.
If you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
UNPACK THE PRESSURE WASHER
1. Remove everything from carton except pressure
washer.
2. Open carton completely by cutting each corner
from top to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
• Main Unit
• Handle
• Accessory Tray
• Billboard
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting
• Oil Pouch
• PerfectMix Siphoning Unit/Hose
• Quick Connect Selector Nozzle
• Quick Connect Kit
• Gun Holder Wireform
• Parts Bag (which includes the following):
• Operator's Manual
• Hardware Kit (which includes):
• Handle Bolts (2)
• Plastic Knobs for Handle (2)
• Plastic Knob
• Small Tree Clips (4)
• Large Tree Clips (4)
Become familiar with each piece before assembling
the pressure washer. Identify all contents with the
illustration on page 6. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly
before operation:
1. Attach handle and accessory tray.
2. Connect detergent siphon hose to pump.
3. Add oil to engine crankcase.

ASSEMBLY

4. Add fuel to fuel tank.
5. Connect pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
8. Select/attach quick connect selector nozzle to
nozzle extension.
Attach Handle and Accessory Tray
1. Slide accessory tray (A) over handle supports (B)
connected to main unit.
2. Push the large tree clips (C) into the holes until
they sit flat against the accessory tray.
C
3. Place handle (D) onto handle supports connected
to main unit. Make sure holes in handle align with
holes on handle supports.
D
4. Insert handle carriage bolts (E) through holes from
inside of unit and attach a plastic knob (F) from
outside of unit. Tighten by hand.
NOTICE By loosening both knobs to the middle
section of the attachment bolt, the upper handle can
fold forward to store flat atop the cold engine. DO NOT
fold the handle down while the engine is hot.
7
A
B
E
F